- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: How to disable / deactivate Armor on RBR50?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How to disable / deactivate Armor on RBR50?
I upgraded my RBR50 router to 2.3.1.32 and then 2.3.1.44. Since the upgrade to 2.3.1.32, I have been experiencing frequent loss of Internet access. Before I downgrade back to 2.2.1.210, I wanted to try and deactivate Armor but can't find an option to do this to see if that is the problem. How do Disable Armor?
Anyone else losing Internet access?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: How to disable / deactivate Armor on RBR50?
What is the Mfr and model# of the ISP modem the NG router is connected too?
I would factory reset and setup from scratch if you haven't already. You can try not enabling Armor at this point, do a back up configuration to file, then give it one more try to see if the reset fixes anything...if not, re-apply the back up config from file.
@slipsibm wrote:
I upgraded my RBR50 router to 2.3.1.32 and then 2.3.1.44. Since the upgrade to 2.3.1.32, I have been experiencing frequent loss of Internet access. Before I downgrade back to 2.2.1.210, I wanted to try and deactivate Armor but can't find an option to do this to see if that is the problem. How do Disable Armor?
Anyone else losing Internet access?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: How to disable / deactivate Armor on RBR50?
I would also reboot ALL equipment starting at your modem and work my way down to see if that makes any difference.
Make sure you leave power off for a few minutes and remove any batteries before cranking back up.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more