NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
New - NetGear Orbi Firmware Version 2.3.0.32 now available...
FW 2.3.0.32 is now available on our support site :
https://www.netgear.com/support/product/RBK50.aspx#download
RBR/RBS 50 Series Only.
To manually update the firmware, there is a need to ...
Orbi defaults to - and recommends - Implicit Beamforming.
I think Fast-Roaming is only applicable for wifi devices that move (not stationary devices).
I have Ring Pro, which can connect via 5.4GHZ AC or 2.4Mhz N.
Strangely, when I first powered on the Ring Pro, it immediately connected to one of my Orbi indoor satellites' 5.4Ghz AC connection that is about 200 feet away (100 feet farther than an Orbi outdoor router that is only about 100 feet away from the Ring Pro) with decent wifi speeds. Unfortunately, after 24 hours or so, the Orbi system then inexplicably redirected my Ring Pro's wifi connection to my outdoor Orbi's (about 100 feet closer) 2.4Ghz connection.
The distances between my wifi devices and satellites vary (4-125 feet), My Ring Pro, which my Orbi iOS apps shows to only be communicating at 4Mbps via 2.4Mhz to my daisy-chained Orbi outdoor satellite, shows very good signal strength and is about 100 feet away (through one 2x4 wall with fiberglass insulation).
Interesting because the or I tech had me check all the boxes, beam forwarding Mimi etc. after firmware update speed good but still getting drops. Did hard reset
Rbs50 rbr50 rbs40 all relatively close drywall contructiom
Rbs50 rbr50 rbs40 all relatively close drywall contructiom
- Options are always good, it would not be configurable if it was best for all. And if it was for most would be default.
I can only confirm my testing with RBK53 set turning on those options made things worse, except MIMO which was a toss up.
gegger wrote:
Interesting because the or I tech had me check all the boxes, beam forwarding Mimi etc. after firmware update speed good but still getting drops. Did hard reset
Rbs50 rbr50 rbs40 all relatively close drywall contructiomI'm running my RBK50 setup with all 3 options checked. Typically 20+ connected devices.
This and setting admin password (because was forced to) are the only changes I made . Oh, and as a precaution, I moved the base WiFi channel to 44 in order to have the cleanest available, based on doing a site survey using an Android tablet running WiFi analyzer.
