- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Orbi RBR20 does not connect to internet through Draytek Vigor 130
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have just purchased RBR20 which worked patchily with BT HH6 so upgraded to Draytek Vigor 130. It is not not possible to connect to internet (BT) at all - any help you can give will be appreciated.
Stephen
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks all. A little late night research showed that I hadn’t entered the bet internet password into the router! Once I had done that all works well.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Orbi RBR20 does not connect to internet through Draytek Vigor 130
What FW is currently loaded?
What is the Mfr and model# of the ISP modem the NG router is connected too?
Is the Orbi system operating in Router or AP mode?
Modem Combo Units:
This would be a double NAT condition which isn't recommended. Couple of options,
1. Configure the modem for transparent bridge mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktop
Be sure to power OFF both Modem and Orbi. Power ON the modem after 1 minute. Power ON the Orbi after 30 seconds. Walk thru the setup wizard with a wired PC and web brower connected to orbilogin.com
@Splnthgs1 wrote:
Have just purchased RBR20 which worked patchily with BT HH6 so upgraded to Draytek Vigor 130. It is not not possible to connect to internet (BT) at all - any help you can give will be appreciated.
Stephen
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Orbi RBR20 does not connect to internet through Draytek Vigor 130
@Splnthgs1 wrote:
Have just purchased RBR20 which worked patchily with BT HH6 so upgraded to Draytek Vigor 130. It is not not possible to connect to internet (BT) at all - any help you can give will be appreciated.
Stephen
Is that this device?
If so, it looks like a straightforward modem, but I would check out the mode. Some modems, such as the Netgear DM200, have to be configured into modem only mode to work with a router.
Can you connect the modem to BT without the router in place?
If not, sort that out first. There's not much help that anyone from Netgear can give on that front.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks all. A little late night research showed that I hadn’t entered the bet internet password into the router! Once I had done that all works well.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Orbi RBR20 does not connect to internet through Draytek Vigor 130
So the Modem is bridged?
Would be helpful if you gave feedback to the questions presented next time
Glad it's working now.
Enjoy.
@Splnthgs1 wrote:
Thanks all. A little late night research showed that I hadn’t entered the bet internet password into the router! Once I had done that all works well.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Orbi RBR20 does not connect to internet through Draytek Vigor 130
@Splnthgs1 wrote:
A little late night research showed that I hadn’t entered the bet internet password into the router!
Just one problem with that solution, BT does not need a password to login to its Internet. Just a username, which, from what I read, can be pretty well anything @btinternet.com. I use my BT email address.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Orbi RBR20 does not connect to internet through Draytek Vigor 130
You are correct, of course, Michael - I meant to say user name where I used bthomehub@btinternet.com and this worked perfectly. Someone on a BT discussion thread said that they used the user name as password and this is what I did.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more