NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
JMU1998
Dec 19, 2017Luminary
Orbi firmware v2.1.1.16 discussion
do we need to do nvram wipe for this 2.1.1.16 Firmware just released today? noticed it downloaded automatically.
ratickle
Dec 19, 2017Apprentice
Installed the v2.1.1.16 firmware this morning because the release notes said it would solve the problem of the satellite NOT listing the attached devices. Not only did this new firmware NOT fix the satellite problem, it seem to have effected the stabilty of my router. My router has rebooted itself twice in the span of four hours. However, in the interest of full disclosure, I did NOT do a factory reset on either the router or the satellite after I installed the v2.1.1.16 firmware. I did do a fresh reboot though.
I've actually gone back to v2.0.0.74 firmware to try and get my network stable again.
webminster
Dec 19, 2017Luminary
ratickle wrote:Installed the v2.1.1.16 firmware this morning because the release notes said it would solve the problem of the satellite NOT listing the attached devices. Not only did this new firmware NOT fix the satellite problem, it seem to have effected the stabilty of my router
Agree with respect to the satellite attached list - was OK until about 3 hours post upgrade, now list of attached devices is empty. Also, the router attached list isn't right, things connected to the satellite show attached to the router. And, other devices that are attached to one or the other aren't listed at all.
Still major issues with connection accounting, 2.0.0.76 wasn't right, but this is still worse.
- jmschnur923Dec 19, 2017Luminary
After installing backhaul was poor in one of my sat. I disabled daisy chaining. I then rebooted. The other sat was now poor back haul. I reenavled daisy chaining and now both sats show good back haul with both showing attached devices. We are now 2 hours into the process.
would be good if there were a clear recipe for updating with daisy chained sats.
- JMU1998Dec 20, 2017Luminary
Did factory reset on both sat and base still showing all connected to base in Orbi App.
- jmschnur923Dec 20, 2017Luminary
I resynced . That seem to do it.
- RemfordJan 05, 2018InitiateForgive what may be a silly question, but how does one check backhaul status between Orbi units?
Thanks.- KenEsqJan 05, 2018Guide
Go to the Orbi Administration web page/Advanced/connected devices
- CotedanDec 30, 2017Apprentice
Updated firmware to latest. All devinces connected to satellite show as WIRED to the main router, so I can’t tell if theyre connecting at 2.4 or 5. With former firmware, this was working fine.
Also Genie network map often shows incomplete list of devices. Normally have 45-50 devices connected but Genie shows just 3-4 at times.