RBR50 / RBS50 Firmware Version 2.6.1.40

Thanks for sharing your experience.

Just a few questions to your setup:

- are you using the Orbi system in Router or AP mode (i use Router Mode)?

- Are you using "Access Control" ?

- Are you using "Port Forwarding" ?

- Are you using "Dynamic DNS" ?

- Have you configured "VPN Service" ?

- Are you using "LAN Address reservation (bind MAC to a fix IP address) ?

- Have you done a factory reset after the upgrade ?

I'm really scared about upgrading, because I made really bad experiences with FW after 2.5.1.16 and a factory reset of the system leads in a lot of work to reapply the configuration (or I load the config backup).

From my point of view, the usual suggestions to do a factory reset after an upgrade is a pain and should not be necessary.

Would be great if you can give me more details about your working setup. Then I could estimate if an upgrade is worth it.

My setup:

RBR50 and 2 RBS50 connected wirelessly and an RBS50 connected on ethernet