I have struggled over and over to get my Orbi to work with AT&T fiber. Can anyone provide a simple to understand step by step way to get the entire system to work together without 404 errors or devices needing to forget Wi-Fi and then resign in?
As a starting point, check out this thread. If you're still having problem, come back here with more specific problem description if possible. Good Luck!
The best advice here is to setup the RBK50 as an access point. Leaving the WiFi on the gateway enabled is up to you as the Orbi can handle the traffic better.
Orbi RBK50 in AP mode, 100/20 Mbps VDSL2, Arris BGW210 gateway
