- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
This happen very sudden like a week ago. Access was fine before.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This happen very sudden like a week ago. Access was fine before.
This happen very sudden like a week ago. Access was fine before.
Current state:
- 192.168.1.1 not accessible
- orbilogin.com not accessible
- https://192.168.1.1 not accessible
- http://192.168.1.1:5000/ result in a 404 not found
- ping 102.168.1.1 response CORRECTLY
- internet seems to be fine but a bit unstable.
- power cycled a few times (waited 10 minutes before restarting)
Is there anyway that i could avoid a factory reset, i have like 40 static ip setup that i'd want to avoid setting up again.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot access web interface (192.168.1.1)
Netgear needs to address it without making everyone do a hard reset.
I have 41 devices connected, that's why I paid over 1k for this system, to not have to deal with these issues.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot access web interface (192.168.1.1)
We have to create posts, or else they would just view this as just some normal kind of bugs.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: This happen very sudden like a week ago. Access was fine before.
What Orbi model do you have?
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
You'll need to factory reset the RBR by pressing the Reset button for 15 seconds then release. Connect a wired PC to the back of the RBR and setup from scratch using a wired PC and web browser at HTTP and 192.168.1.1 or orbilogin.com and walk thru the setup wizard. Do not attempt to use the orbi app for this. I would disconnect the RBR from the ISP modem/ont temporarily until you get thru the setup wizard.
@superx3man wrote:
This happen very sudden like a week ago. Access was fine before.
Current state:
- 192.168.1.1 not accessible
- orbilogin.com not accessible
- https://192.168.1.1 not accessible
- http://192.168.1.1:5000/ result in a 404 not found
- ping 102.168.1.1 response CORRECTLY
- internet seems to be fine but a bit unstable.
- power cycled a few times (waited 10 minutes before restarting)
Is there anyway that i could avoid a factory reset, i have like 40 static ip setup that i'd want to avoid setting up again.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more