NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Wired backhaul configured but still shows WLAN Backhaul Statistics
I've got an RBR-50 (configured as an AP) with satellites configured using wired ethernet backhaul. The GUI shows all the satellites connected using wired backhaul. When I go to advanced -> admin...
After the reboot, there was a little traffic on the WLAN backhaul, and it's been quiet since, outside of the polling/beacon. All satellites show up as wired.
The statistics for WLAN are odd. For example, the WLAN Backhaul Tx B/s and Rx B/s values gradually decreased over time to now, where Tx is 0 and Rx is 2, as if the metric is Bytes/Up Time and not Bytes in the polling interval.
It's been just over a week, and everything is working well. In the last 7+ days, there has been very little WLAN backhaul traffic.
After the last reboot, there had been 526 RxPkts, now its at 2248 RxPkts. The TxPkts has continued to increment from its polling/beacon, I believe this must be the RBR50 sending a beacon for potential satellites (perhaps new ones?)
I never did as ekhalil recommended and reset all the satellites.
What I did do was move all the satellites to an 8 port switch, everything seemed good. Then moved back to the 24 port switch, everything has been right since.
No idea why it had gotten to the point where it was heavily using the WLAN backhaul even through it showed all the satellites as wired.
It still shows as wired on the backhaul now, as it did before, but all the traffic is not on the WLAN backhaul, it's on the wired LAN.
Thanks to everyone that has chipped in, I appreciate your help!
