- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: RBS850s Show Different Statuses But Are Identical: Bug?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
My RBR850 is running firmware version V3.2.17.12_1.4.14 and has never performed better. Speeds are high and connectivity is rock solid.
I have three RBS850s also connected -- two via hard wire and one via wireless backhaul.
Satellite #1 resides at 192.168.1.2; it's firmware is V3.2.17.12_1.4.14; Wired Backhaul
Satellite #2 resides at 192.168.1.3: it's firmware is V3.2.17.12_1.4.14; Wired Backhaul
Satellite #3 resides at 192.168.1.4; it's firmware is V3.2.17.12_1.4.14; Wireless backhaul
Now here is the odd part; I looked at each satellite's web GUI and each one had slightly different issues. Refer to the three attached images for the following
Satellite #1 Shows the router "RF Fan" as solid gray (I presume because of wired backhaul?) and it shows that the security type of the 2.4 and 5G networks are enabled as WPA-PSK
Satellite #2 shows the router "RF Fan" as solid gray (I presume because of wired backhaul?) and it shows that there is NO SECURITY for the 5G WiFi and WPA2-PSK for the 2.4G WiFi
Satellite #3 shows the router "RF Fan" as Gray on 2.4G and Blue on 5G (I presume because of wireless backhaul?) and it shows that there is NO SECURITY for the 5G WiFi and WPA2-PSK for the 2.4G WiFi
So this begs a few questions.
1. Why would satellites #2 and #3 show NO SECURITY on only the 5G WiFi network? (There are active devices attached to those satellites)
2. Is there really security on the 5G WiFi Channels and the indicator is just a bug?
3. Does the graying out of the 5G wireless backhaul indicate when in Wired mode those radios are inactive? (I thought it stayed active in case the wired network went down)
4. Is there such thing as 2.4G wireless backhaul? (would the RF Fan ever be blue on top?)
Here is Satellite #1 Web Gui: Note the fan and the 5G security
Here is Satellite #2 Web Gui: Note the fan and the 5G security
Here is Satellite #3 Web Gui: Note the fan and the 5G security
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks much.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RBS850s Show Different Statuses But Are Identical: Bug?
I ran into a odd issue this past week with 1 of my RBS, wired. Was showing "out of sync" on the RBRs status page. Other RBS was fine. RBS web page showed it was working fine and had connected clients connected. No front LED was on or blinked. Just the status on the RBRs web page was not Good. I had to power OFF the RBS, reset, wireless re-sync the RBS to the RBR after it finally synced, wire connected it again and it's been online and showing GOOD as the status since then. No idea why the status changed or what happened. I gathered logs and sent off to NG for review. No responce.
I would reset and resync your RBS.
When RBS are wire connected, the wifi icon for 2.4 and 5Ghz will be grayed out. This is normal.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RBS850s Show Different Statuses But Are Identical: Bug?
Thanks @FURRYe38 , I will power cycle them later today and check status. If it is still odd, I will reset the satellites as recommended and check. Either way I will report back what I find.
Funny thing is that the network is running better than ever; I should have never looked at the satellite pages! LOL
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RBS850s Show Different Statuses But Are Identical: Bug?
Ya things are working well here too. Was an odd thing I found with mine. The other day, I had my 2nd gen NEST disconnect and would not reconnect at all which was a odd thing, never had seen that before since I had the Orbi AX installed. That took just a reboot of the RBS. All been ok since that night. Makes me wonder if NG does soemthing from behind the scenes remotely.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks much.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RBS850s Show Different Statuses But Are Identical: Bug?
Good to hear. You might keep an eye on that once in a while to check. Hoping there isn't a odd sync issue in new FW.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RBS850s Show Different Statuses But Are Identical: Bug?
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more