- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Webinterface GS108PE v2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I got a Netgear GS108PE v2 today and I tried to access the webinterface over IP.
My DHCP assigns an IP address but I can't access it.
If it's not a managed switch? Why does it say DEFAULT ACCESS password: password ?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to the Community!
The GS108PEv2 switch does not have a Web GUI but can be managed by using the Configuration Utility that can be downloaded on the Support page. Please click here to check,
You will use the default password to access or to configure the switch using the Utility.
HTH
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to the Community!
The GS108PEv2 switch does not have a Web GUI but can be managed by using the Configuration Utility that can be downloaded on the Support page. Please click here to check,
You will use the default password to access or to configure the switch using the Utility.
HTH