- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
no ip-adress
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This afternoon my switch gives this message. I had some difficulties connecting my STB.
XS716T-1 DNS_CLI[dnsTask]: dns_client_util.c(1718) 1468 %% DNS Client: no ipv4 or ipv6 address found in response for request id 2943
Where to look?
Jaap
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Problem is solved by changing the DNS-server adress to a proper one
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: no ip-adress
Was everything working fine before? Are there any changes made within the settings of the XS716T switch or with the network setup?
How is everything connected? It would be best if you can post a your detailed network diagram showing the connected devices.
What is the current firmware of the XS716T switch?
What is STB?
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Problem is solved by changing the DNS-server adress to a proper one