- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
M4250-10g2f Keeps rebooting
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
M4250-10g2f Keeps rebooting
Hi All,
I'm experiencing some issues with my M4250
I tried to factory reset with the button on the front, after this the switch keeps rebooting/crashing every 1/2 minutes.
Has anybody experienced this before?
Cheers,
Barry
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: M4250-10g2f Keeps rebooting
This forum is not a tech support site. Better to send us an email at proavdesign@netgear.com and one SE will assist you today.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: M4250-10g2f Keeps rebooting
Hi Laurent,
Thanks I have sent them a e-mail.
I do have another question.
i've made a shure controll network.
My shure devices see each other. But my computer on the other hand, does not. When I bypass the netgear, everyting works fine on my computer. Do you have any idea perhaps?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: M4250-10g2f Keeps rebooting
If your computer is a Mac, you can go to the AV UI and go to Configure/Multicast. Click the port where your computer is, and activate "Force Multicast" mode on it. Click apply and save!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: M4250-10g2f Keeps rebooting
That worked, thanks!
Should I enable that for all my ports then? Because it's not an install. My Personel should be able to plugin their laptop in any port.
cheers
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: M4250-10g2f Keeps rebooting
Thank you
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: M4250-10g2f Keeps rebooting
Awesome, one last question 😁
I see that some of my SFP fiber uplinks do not contain all vlan's any way I can solve this?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: M4250-10g2f Keeps rebooting
Can you follow them step by step? In between M4250 and other NETGEAR AV Line Switches, Auto-Trunk is placing all VLANs automatically.
If you are up linking to third party switches, you should just place a T (clicking twice) on the fiber port in every VLAN/Profile, matching the other side of course if keeping one VLAN untagged (green check box).
Thank you