- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Sudden changes to port forwarding
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sudden changes to port forwarding
I'm using R6400v2 and have been for several years. I run a web server on port 80 and 443, and allow ssh to my server from certain IP ranges. Port forwarding has been in place for years and has worked perfectly.
I recently had a power surge and had to replace a network switch, but the router appeared unaffected.
Except: ports 22, 80 and 443 no longer reach the correct server. Ports 80 and 443 appear to be connecting to the router itself, at least from the HTML returned, and port 22 is ignored completely. Ssh from a machine outside the network just sits and waits, eventually timing out.
The Advanced Admin -> Advanced Setup -> Web Services Management no longer has a flag to control outside admin access to the router, just the following:
Local Management: |
[ ] Always Use HTTPS to Access Router |
Thanks for any ideas
Tim
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Sudden changes to port forwarding
Have you factory reset the router and setup from scratch?
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Power off the ISP modem/ONT for 1 minute then back ON as well...
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more