- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
RNDU2000 Problem after factory reset
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone,
A friend of me gave me its RNDU2000.
I tried a factory reset. RAIDar find device at restart and gave me choices. I choose XRAID2.
After several minutes (tests disks, intallatation...) device reboot and stuck with these LED configuration : Power On, act On, 1 On, 2 Blinking.
RAIDar can't find anymore and i got no access to admin frontview.
I changed Hard Disks, make one more time a factory reset and I got same results...
Device answer to ping.
Any idea ?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The firmware on the flash was corrupt so I put the latest firmware on the flash.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RNDU2000 Problem after factory reset
Sent you a PM. Please check your PM inbox.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RNDU2000 Problem after factory reset
MDGM fix problem.
Thank you so much !
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The firmware on the flash was corrupt so I put the latest firmware on the flash.