- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
"No volumes exist" after attempting to replace a drive
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"No volumes exist" after attempting to replace a drive
I've had my ReadyNAS for several months. I began with 2x3TB drives, and ended up expanding it to 4x3TB using X-RAID. The unit has worked well. I decided to expand the array by installing larger drives, so I purchased a 6TB drive that was on the ReadyNAS compatibility list. After upgrading the firmware to the latest 6.6.1 OS, I removed one of the 3TB drives, and installed the 6TB drive. Shortly afterward, the system reported that the array was degraded, and started a resync. At this time, the data was still accessible, and appeared to be running well. After a few minutes, the shares were inaccessible, and the web interface was no longer responding properly. I left the system in this state for 90+ hours, hoping that I just needed to give is time to resync. When I have all four drives (3x3TB +1x6TB) installed, the system will not boot up at all, as it will report that it failed to boot. If I remove the 6TB drive, and attempt to boot on the other 3x3TB drives, the system will start, but reports the following:
- Remove inactive volumes to use the disk. Disk #1,2,3
When I click on "Shares" I receive the followin error:
- No volumes exist
All three drives are displayed in orange on the "Volumes" page.
At this point, if I install the 6TB drive into slot 4, all 4 bays are displayed in orange, and the "Remove inactive volumes" error includes "1,2,3,4" in the error.
I have attempted to contact support, however the phone line tells me I have to purchase a support agreement. When I attempt to look as the support agreements, I'm unable to figure out how to choose and purchase a support option.
I am using this device primarily to store videos for home use, and the device is not used in an office
My most important data *should* be backed up, but I'd still like to attempt to recover any usable data if possible
I'd like to know how to purchase a single incident support plan for this issue, or determine any other options available.
I'd like to know if there are any commands I can do to attempt to access the data on the array
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: "No volumes exist" after attempting to replace a drive
Can you send in your logs (see the Sending Logs link in my sig)?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: "No volumes exist" after attempting to replace a drive
Thanks. This is definitely something for support. From what I can see you have not yet registered your device?
You should go to my.netgear.com and register your device. That would be the first step.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: "No volumes exist" after attempting to replace a drive
Thank you for your assistance, I have purchased a 3 year support plan and have submitted a support request.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: "No volumes exist" after attempting to replace a drive
Did you get a resolution to this problem? I have exactly the same issue...