- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-01-26
08:29 PM
2021-01-26
08:29 PM
After a recent reboot, my RBS50 satellite is in a constant state of pulsing white LED on the top (the power LED is green).
I've tried the 30-30-30 reset, I've tried just a regular reset holding down the button with a pin for 15 seconds, I've tried to connect to satelitte via tFTP from a wired PC connect - nothing works, there is no way I can seem to communicate with the device and it cannot be added to my existing Orbi network (RBR50, RBS50 and RBS20).
It wasn't in the middle of a firmware upgrade and nothing appears to be faulty or indicate there is a problem (i.e. Red power LED).
I just want to get it back to factory defaults so i can add it back into my network.
Any suggestions ?
Solved! Go to Solution.