Attempting to setup an RBR50 that I purchased over a year ago. Initial setup appeared good. Now unable to access Advanced tab (via either Orbilogin or IP address directly). Additionally, firmware is 1.3.2 series. Can't update since I can't get to the Advanced tab. Tried a Factory reset and wind up back to same state. Any suggestions welcome before the big trash can in the back yard. Thank you. Jan Erik

Vaguely remember this happened under some conditions. Any Internet "security" stuff intercepting the Web traffic probably? I hope some Netgear moderator like Dustin_V has some more ideas for the recovery, so a newer firmware image can be installed.

Attempting to setup (old) RBR50, unsuccessfully

7 Replies

schumaku
Guru
Feb 17, 2020
That would be expensive trash - try a different browser to start with.
- jneun
  Aspirant
  Feb 17, 2020
  I have tried the three browsers I have on the PC.
  - schumaku
    Guru
    Feb 17, 2020
    Vaguely remember this happened under some conditions. Any Internet "security" stuff intercepting the Web traffic probably?
    
    I hope some Netgear moderator like Dustin_V has some more ideas for the recovery, so a newer firmware image can be installed.
FURRYe38
Guru
Feb 17, 2020
Might consider updating to v2.5.1.8 at some point.
- jneun
  Aspirant
  Feb 18, 2020
  Agree. My issue was getting the ability to apply the updates. I've since taken the router and satellite to the level you suggest.
  - FURRYe38
    Guru
    Feb 18, 2020
    You should be caught up now.
    Enjoy. :smileywink:

Forum Discussion

Attempting to setup (old) RBR50, unsuccessfully