NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi overnight speed decrease
Trying to figure out why wireless speed drops while logged off overnight. I routinely get 200+ MBPS all day through the wireless connection...however, after logging the computer off at night, then lo...
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Are wired LAN speeds still good?
Modem is a Hitron E31N2V1 (supplied by internet provider), but I can't see how it would matter. The Orbi router handles all DHCP assignments, etc. and the issue is limited to wireless connection.
Tom
What is the mfr and model# of this wifi adapter that the PC is using?
What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router
If you turn OFF The RBS, does the RBR show the same problem?
What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?
hTry enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings
Try disabling the following and see:
Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).You might update to v16 on the system, factory reset and setup from scratch. https://community.netgear.com/t5/Orbi/RBR50-RBS50-Firmware-2-5-1-16-Update/m-p/1897955/highlight/true#M89460