Orbi RBR50 Port Forwarding not working

Question

I just cannot get port forwarding working on the RBR50.
&nbsp;
It’s on the default setting of Router and connected to BT with an Openreach modem via PPPOE
&nbsp;
All I’m trying to do is make an http page on a Raspberry Pi webserver (192.168.1.254) accessible to the outside world.
&nbsp;
I have Reserved the Pi’s ipaddress in Lan Setup before adding it on the port forwarding page.
UPnP is not enabled
It has a public WAN IP address
&nbsp;

Hardware Version
&nbsp;&nbsp;&nbsp;RBR50

&nbsp;

Firmware Version
&nbsp;&nbsp;&nbsp;V2.1.4.10

&nbsp;

GUI Language Version
&nbsp;&nbsp;&nbsp;V1.0.0.314

&nbsp;

Operation Mode
&nbsp;&nbsp;&nbsp;Router

&nbsp;

LAN Port

&nbsp;

MAC Address
&nbsp;&nbsp;&nbsp;A0:40:A0:77:05:XX

&nbsp;

IP Address
&nbsp;&nbsp;&nbsp;192.168.1.1

&nbsp;

DHCP Server

&nbsp;&nbsp;&nbsp;On
&nbsp;

I would have thought this would be enough but it doesn’t work…
Is there more that needs to be done?
&nbsp;
Any advice appreceated.&nbsp;

DarrenM · Answer

Does that bt modem have a built in router? if so do you have it bridged or set to modem only?

&nbsp;

DarrenM

FastFreddy · Answer

No router - just bridged. Its just a modem...
&nbsp;
F

DarrenM · Answer

What port are you trying to forward?

&nbsp;

DarrenM

FastFreddy · Answer

I have a Raspberry pi on the network serving a web page, so port 80.
Just want to make it accessable on the wan.
&nbsp;
It's really only a test. I actually need to get my VOIP phone working but thats another story...
&nbsp;
F

DarrenM · Answer

Usually port 80 is limited to be accessed from your internal network; the reason being it usually is assigned to the web admin interface.

&nbsp;

DarrenM

Forum Discussion

Orbi RBR50 Port Forwarding not working

9 Replies

Hardware Version	RBR50

Firmware Version	V2.1.4.10

GUI Language Version	V1.0.0.314

Operation Mode	Router

LAN Port

MAC Address	A0:40:A0:77:05:XX

IP Address	192.168.1.1

DHCP Server	On