Orbi VPN setup generates 400 error

Question

Orbi generates 400 error when trying to enable VPN. Armor security not enabled. Circles (not standalone) enabled.

Check the ENABLE VPN

tick UDP

set start port to 12973 (also tried1273)

tick UDP

set end port to 12974 (also tried 1273)

tick AUTO

SAVE generates the 400 error - Server is not able to handle this request

Any ideas?

Thanks in advance

CrimpOn · Answer

My VPN works.&nbsp; I chose "All sites on the Internet &amp; Home Network" rather than "Auto".&nbsp;Can you specify which Orbi router this is and the firmware release number?(Hint: "latest" is not helpful.)&nbsp;Thanks&nbsp;

Retired_Member · Answer

Sorry - I tried to paste this into the MODEL field on the blog form, but it turned out to be a pull down.

Orbi RBR 40 ver 2.3.5.30 (No updates available)

Tried your config - All Internet, etc - same reaction -

CrimpOn · Answer

Just checking (I am tediously "literal"), clicking the "Apply" button results in error 400, not "Save"?

CrimpOn · Answer

Oh, sometimes trying a different browser helps.&nbsp; (I cannot remember how to "clear cache", so I just open a different web browser when I run into problems).)

Forum Discussion

Orbi VPN setup generates 400 error

4 Replies