NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
RBS50 config sync with Internet access
Two issues: 1 - satellite 2 stuck in config sync but it was providing verified Internet access to a device connected by Ethernet cable and also apparently wirelessly to two iOS devices. 2 - Another interesting item is the two wirelessly connected iOS devices showed on the Orbi App and also the router login web page as connected to the 5G guest network but my main network name was shown as their wireless network connection. I did not and still don’t have my guest network enabled.
Is this even possible or have I been hacked?
i tried without success to sync satellite 2. Finally synced it by using an Ethernet cable to the RBR50 router. Then returned it to it’s location and had good network for about 10 minutes, then problem returned. Router and satellites are firmware v2.3.1.60. Access control enabled. Suggestions?
Do you administer the Orbi using the web interface or a smartphone app?
There have been several questions raised about Access Control and the smartphone app, e.g. Orbi is not doing what it is supposed to.
One quick check is to disable Access Control (turn it off), then reboot: router first, satellite 1, then satellite 2.
6 Replies
I forgot to add that originally I had access control set to allow all new devices. After the issues described above, I changed access control to block all new devices. Now my iOS devices do not have Internet access via satellite 2 and show Internet access as blocked by access control. After de-powering (unplugged it) satellite 2 my iOS devices have Internet access via either the router or satellite 1.
Do you administer the Orbi using the web interface or a smartphone app?
There have been several questions raised about Access Control and the smartphone app, e.g. Orbi is not doing what it is supposed to.
One quick check is to disable Access Control (turn it off), then reboot: router first, satellite 1, then satellite 2.
I administer with the web interface but observe frequently with iPad app - no actual changes are made to configuration with the app.
i was ready to attempt your suggestion and powered up the satellite (sat 2) for the first time today and voila, it almost immediately achieved a blue ring and the web app showed direct connection to the router, problem magically corrected itself. I hope it lasts. By the way, this is the first problem I’ve had with my Orbi system in over 17 months since purchase.
Thanks for for the assistance! Also, do you know to force the RBR50 router to only accept manual firmware updates? I can’t find that option anywhere in the web interface pages.