NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Wired ethernet backhaul connection does not show status on orbilogin site
Hi I Use the Orbi RBK23-100PES (1 router + 2 satelites) I connect the satelites using wired connection (ethernet backhaul connection) I first sync the system not using the wired connection, ...
- Since your're using wired backhaul, please make sure Daisy Chain is disabled.
- What wired devices do you have connected to Orbi?
- Was the IP range 10.0.0.x selected by you or was it set by Orbi at initial setup?
In trying to diagnose Ethernet backhaul issues in the last few weeks I have noticed lots of glitches in the web interface, such as wireless devices shown as wired and lagging connection status updates for the satellite. After it appears you have a good connection, try logging out from the web interface and restarting your browser.
Hi
Thx
I disable the Daisy Chain, but still i do not see the devices as connected
I double check that this setting is turned off after the system has been reset (this change required system reset)
My Home is wired using Netger GS 608 1Giga switches (4 speard is misc places at home). I have several devices connected wired at home (PC's, TV's Streamers, printer and more)
The IP range was set automaticly to 10.0.0.x when i start the setup processI believe you are in a double NAT condition with a router somewhere behind the Orbi.
Are you able to describe precisely by make/model what is upstream of the Orbi (e.g. cable modem, switch, etc) and what is above that?
Solution is there to get this working properly, but you will probably have options to decide
Hi
Attached my home network diagram
