NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
LB2120 and Ubiquiti EdgeMax - LAN resetting
I have an LB2120 running the latest firmware connected to a Ubiquiti EdgeMax router running also the latest (1.9.7). When I place the LB2120 in bridge mode, the EdgeMax gets an IP and sets the defaul...
Hi mgandalf,
You have mentioned that issue did not occur when you have downgraded to previous firmware of your EdgeMax and it only happens with the latest firmware. Have you checked with Ubiquiti if there is a known issue with the latest firmware?
Yes, I have the question out to them as well.
- Mark.
I'm having the exact same problem with a USG. Lan comes up, the connection is stable in bridge mode but as soon as the Netgear get's under a load (about 30 seconds) the power light on the 1120 blinks amber and the LAN connection resets. Newest firmware on the 1120 and current on the USG.
Mark, do you have a link to a Ubiquiti thread or a case number I can reference if I call them?
My thread is more related to the issue of a default outside of the /32 the modem gives me for an IP, which started me down the road of upgrading the Ubiquiti and Netgear firmware.
I have done a bit more investigation, however. I tried hard-setting the link speed all the way from 10/half to 100/full with no difference. I also placed a 1gig switch inbetween the modem and the router - no change. This doesn't seem to be a problem on the Ubuquiti end in my opinion. The modem's LAN interface shouldn't be disconnecting/resetting like it does.
- Mark.
Based on that I would agree, this seems to be a Netgear bug. I may return mine and get a new one just to see if it's a hardware problem.