NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Nighthawk m1 - 5510 port state: filtered
I'm owner of MR110-100EUS that works with software: NTG9X50C_12.04.02.00 It does not matter if I connect with WI-FI, or with USB tethering, the port 5510 is always filtered so i can't access to cons...
Ok, i found that it does not matter if port is filtered or not.
It is enough to connect with USB, then just use telnet 192.168.1.1 5510you will see just black screen without any kind of information, like i show below:
It is confusing, no message that you connected etc. ;)
So, once you will see this weirdy-looking black screen without any responsse - it is just enough to start type the AT commands.
Ok, i found that it does not matter if port is filtered or not.
It is enough to connect with USB, then just use telnet 192.168.1.1 5510
you will see just black screen without any kind of information, like i show below:
It is confusing, no message that you connected etc. ;)
So, once you will see this weirdy-looking black screen without any responsse - it is just enough to start type the AT commands.