NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Nighthawk M6 Pro Ethernet port
After recent automatic update, Ethernet port on nighthawk M6 Pro not working. Can toggle it on/off, but has no output signal. Any troubleshooting suggestions?
-- POSSIBLE (partial) FIX --
based on a suggestion in a reddit comment from @HairyFarmer465 on a post re: same matter, if you put it in bridge mode, it turns off wifi but ethernet works and doesn't cut out after 4 min!
https://www.reddit.com/r/NETGEAR/comments/1n9bnlr/nighthawk_m6_pro_help/
to put it in bridge mode... go to settings > ... more > IP Passthrough > ON -- device will reboot and then it will show a "BridgeMode" icon/button where it had previously showed the WI-FI icon.
i'm at 45 min now with a solid connection.
this shuts off its ability to be a wifi hotspot and the bridge mode might not work for everyone's needs, but as a temp fix, it's working for me so far.
Just switched it over to IP Passthrough/Bridge mode. It seems to be working so far, although I did lose wireless function through the hotspot. I have been connected to a router for 2 1/2 years and not using the wireless from the hotspot anyway until this latest update.
AT&T initially blamed Netgear, but Netgear is adamant that it was an AT&T update. Both said they are getting flooded with calls and Netgear said they were contacting AT&T and pushing them
to fix it. Maybe if the calls continue, something will be done.
I pushed back at AT&T and they said they would contact me back. I won’t hold my breath for that one.