NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
rookwood52
Jul 01, 2020Follower
not broadcasting wifi mr2100
hi, mr2100 router is not broadcasting wifi again today, though it is providing good internet access via the ethernet socket to my PC's. On the touchscreen it shows a X through the wifi emblem. Has done this before a couple of times in the last 2 months but rebooting worked, today wifi does not work, nor switching off for several minutes
tapping or holding down the wifi emblem has no effect on the large X over the emblem, other than bring up the "battery fully charged" page that rapidly swamps everything else, even though it was disconnected from the power lead 2 hours ago. Its 7 months old. I have have made sure the wifi timer is "never off"
Hi rookwood52
Welcome to NETGEAR Community!
Please provide the device SKU (MR2100-xxxxx) and firmware version.
If issue re-occur, please access MR1100 settings page, go to Settings > Wireless > "Broadcast Wi-Fi Name SSID" should be checked.
Kindly check as well if WiFI Standby is set to Disabled or Enabled.
Regards,
Blanca
Community Team
1 Reply
- Blanca_ONETGEAR Employee Retired
Hi rookwood52
Welcome to NETGEAR Community!
Please provide the device SKU (MR2100-xxxxx) and firmware version.
If issue re-occur, please access MR1100 settings page, go to Settings > Wireless > "Broadcast Wi-Fi Name SSID" should be checked.
Kindly check as well if WiFI Standby is set to Disabled or Enabled.
Regards,
Blanca
Community Team