NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
VLAN Configuration Not Getting Applied and Saved
Hi, We use NetGear Switch M4200 Poe Switch in our lab. Recently after Firmware Update on this system, VLAN configuration doesn't get Applied or Saved (Logged in as admin). Has any one faced this ...
Have you tried to access the the M4200 switch via CLI? If not yet, kindly try it and check if it would respond.
You can open a support ticket with the NETGEAR Support Team here at anytime for further hardware check. Kindly state what happened and the status of your M4200 switch.
Regards,
DaneA
NETGEAR Community Team
Hi DaneA,
Did the configuration of VLAN through CLI and it does work. VLAN Configurations done from CLI, are visible in UI too. At least this CLI access is working, this is a good option.
But VLAN manipulations from UI doesn't take any effect. Having UI would be really useful and easy. How can this be resolved.
Awaiting your advise.
Thanks
Deepak
I suggest you to perform a factory reset on the M4200 switch through the CLI by using the clear config command on Privileged EXEC mode then reconfigure the switch from scratch. Also, check if you will be able to access the web-GUI then configure VLANs using the web-GUI.
Regards,
DaneA
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
