NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
GS108Pe v3 interrupted during firmware upgrade and no longer provides access to GUI
Hi folks, I have looked at a number of threads on a similar subject and sort of received an answer. 1/. the device still works as an unmanaged switch 2/. reset to factory defaults does not work 3...
With the device being in bootloader mode, the default 192.168.0.239/24 can be in place - so plan a computer in that same subnet.
Thank you. I will give your suggestion try tomorrow when I have free access to the switch.
Ian
With the device being in bootloader mode, the default 192.168.0.239/24 can be in place - so plan a computer in that same subnet.
Hi folks,
thank you for the suggestions. I had success this morning with accessing the switch, it immediately wanted to continue the firmware upgrade.
Since completing the upgrade it is much moree responsive. A little side not for others in this position, the reset to default did not work while in boot loader mode.
All is now good.
Ian
rfcat_vk wrote:
...I had success this morning with accessing the switch, it immediately wanted to continue the firmware upgrade.
Ian,
For the other readers, what had to be done so the update process continued? Was the switch on it's default IP 192.168.0.239/24 and reachable on this subnet, e.g using a Web browser?
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
