NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Web interface not reachable
Hi,
I configured the switch as follows:
IP-Adress: 192.168.4.21 (static)
Port 1: Trunk (tagged), PVID 1 connected to Router
Port 2: VLAN 101 (untagged), PVID 101 ...
Most of these Smart Managed switches don't allow to configure a VLAN ID for the management - therefore the management traffic from the switch is untagged.
Hi nicku,
Welcome to our community! :)
It seems that everything looks good on your setup. I suspect that there is something that floods your switch that's why it became unresponsive after a while. I believe that the PC that you are using for setup is connected to port 5. In order for us to assist you better with the issue, kindly provide us additional information. I have summarized my questions below:
- How about the LED status of the ports?
- Can you still ping the switch or any other device connected to the switch?
- Does it happens right after you apply those configuration?
- Does it work for a while then it will became unresponsive?
You may also upgrade the firmware to its latest version. If ever that this device is a brand new unit, I suggest you to open a chat / case online on NETGEAR support and please let them know the status of your switch.
If ever your concern has been addressed or resolved, I encourage you to mark the appropriate reply as the “Accepted Solution” so others can be confident in benefiting from the solution. The NETGEAR Community looks forward to hearing from you and being a helpful resource in the future!
Regards,
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
