Forum Discussion

Aspirant

May 07, 2017

Site to Site SRX5308 y Zyxel USG50

Hi. I have done the Site to Site configuration of a NETGEAR with a ZYXEL and do not connect. I have reviewed the configuration and I have updated the firewall and in principle everything is fine, b...

Solutions

DaneA

NETGEAR Employee Retired

May 08, 2017

Hi LuisMaria,

Welcome to the community! :)

I'm not sure if you have already came across with the article below. However, kindly use the article below as reference guide on how to configure box-to-box IPSec VPN:

Configuring a Box to Box VPN on ProSAFE/ProSECURE routers using the VPN Wizard

Make sure that the WAN IP address registered on the SRX5308 and Zyxel USG50 are Public IP addresses. Also, be reminded that the LAN subnet on the SRX5308 should different on the LAN subnet of the Zyxel USG50. For example, if the LAN subnet on the SRX5308 is 192.168.1.x, then the LAN subnet of the Zyxel USG50 should be different like 10.10.10.x or 192.168.9.x.

Regards,

DaneA

NETGEAR Community Team

DaneA
NETGEAR Employee Retired
May 11, 2017
LuisMaria,

I just want to follow-up on this. We’d greatly appreciate hearing feedback.

Regards,

DaneA

NETGEAR Community Team
- LuisMaria
  Aspirant
  May 11, 2017
  I have done everything from the documents and configurations that NETGEAR has supplied to me and nothing at all (what I do not know if the connection problem is NETGEAR or ZYXEL
  If you can guide me in things that I can try, I will do it agusto
  - DaneA
    NETGEAR Employee Retired
    May 16, 2017
    LuisMaria,
    
    Kindly post screenshots of the VPN settings you have configured on the SRX5308 as well as the Zyxel USG50 so that other community members who are familiar with Zyxel could chime in and share their knowledge.
    
    Regards,
    
    DaneA
    
    NETGEAR Community Team