NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
amber light blinking on power
Hi, I'm trying to configure and reset a few APs that used to be part of another network that was controlled by NetGear Wireless Management switch. However the APs continue to flash amber light, r...
Welcome to our community! :)
It seems that the AP is connected before to a wireless controller. May I know the specific model of the controller? You may need to access the secret IP in order for you to upload the standalone firmware of the AP. Please try to go to this IP: 192.168.0.160 and please let me know if you can access it.
Regards,
John
NETGEAR Community Team
Hi John,
Thanks for the suggestion, I have tried your suggestion, but i couldn't ping or access via browser the 192.168.0.160 address.
The model of the controller that it had been connected to would be the Pro Safe WC7500 controller.
Thank you :)
Please try to do a factory reset by pressing the reset button for 30 seconds, then turn it off. Continue to hold the reset button for another 30 seconds and turn it on while still holding the reset button for another 30 seconds then release.
Please let me know if that would work.
Regards,
John
NETGEAR Community Team
Hi John,
As mentioned in my original post (30/30/30 reset method) I have already tried that and unfortunately it has stayed amber.
I didn't think factory reset to a standalone access point will be this difficult.
Regards
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
