Looking for network with seamless mesh roaming for warehouse application

---

QuantumTech wrote:

... to replace my existing warehouse network (microtik) ...

 

Our warehouse is a large L shape of nearly 10000 sq ft, and has a lot of metal in it (rows of racking with steel drums or pails full of liquid), with 24 ft high metal ceiling. We also have an office space, lunch room and laboratory which it would be nice if it had hte same wireless network over it, but not essential. Please let me know if anyone has any advice or experience in this area.

---

Was and is this all wireless? Just one "primary" WiFi and then bring up repeaters - no matter it these are bunches of WiFi repeaters or mesh class satellites - will never lead to a good result.

My advise goes towards some clever network design. The nearer you bring wired network t the wireless clients, the better the wireless can perform. Stay far away from consumer and throw-in mesh system, especially if you intend to combine the warehouse and the office/lab/lunch room where wires to the rooms are required. Assuming the central location is in the middle of this L, set up some wired Ethernet with PoE switches and APs, Towards the two wings of the L-building, you might consider some powerful tri-band AP allowing a dedicated bridge to the towards 2/3 of the length to another similar AP. Depends on the latency and performance expectations. You might not need WiFi 6 in the warehouse, so e.g. a pair of WAC540 would do it for each half of the L section  (also to allow one wireless hop out to the far ends), in the center you might consider some WAX610 e.g. for the office. All management done by Netgear Insight.