Orbi Pro 6 SXR80 - Firmware Update V3.2.0.108 is a Disaster

RJU064 & netgear 

I've had EXACTLY the same experience as RJU064 this morning. The auto-firmware update downloaded v3.2.0.108 to my SXR80+SXS80 deployment (running in AP Mode) and after several hours of inconvenience (thanks NetGear), I found this article.

To add to the remedial steps RJU064 stated in their 'fix' (aka downgrade to v3.1.1.102 asap), I also recommend watching https://www.youtube.com/watch?v=6N1atnfZGYE to disble the auto-update feature; which natively appears to be ghosted/locked in the routers' web admin 'Firmware Update' section.

NOTE: The YouTube video misses a config line though... there are 4 you need to modify:
 > nvram set orbi_auto_upgrade=0
 > nvram set auto_check_for_upgrade=0
 > nvram set auto-update=0
 > nvram set orbi_auto_upg=0 (not shown in the YouTube video)

NetGear - I think this firmware update should be retracted until stablised; since EVERYONE is going to reboot their kit as part of the upgrade and I strongly doubt whether folks will know to remove all LAN cables everytime a device is power cycled.