NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Wired MS80 works but app shows disconnected
Odd situation,
I've been troubleshooting my MR80 and 2 MS80 Satellites. I have one MS80 (Living room) Wireless backhaul and one MS80 (Barn) Wired at about 160 feet of CAT6. The Wired Barn is getting a normal 100-150Mbs down but the MR80 base indicates that it's disconnected.
I just updated everything to V1.1.7.14
my ethernet cable tester says everything is fine on the cable. I was able to direct connect between the MR80 and the MS80 with a short cable to get the upgrade done.
I don't see how the system will work but display that it's disconnected.
Thanks!
Thanks much for the response. I bit the bullet and did a factory reset. For this instant in time, everything is working. Over the last couple of days it'll work for a few hours then bail. Fingers cross that it'll remain stable. I'll try to figure out how to mark this as resolved. 🙂
Thanks again!
3 Replies
If it says its down in the app, what does it show in the GUI? (through the browsers)
It wouldn't be the first time the app wasn't correct
Thanks much for the response. I bit the bullet and did a factory reset. For this instant in time, everything is working. Over the last couple of days it'll work for a few hours then bail. Fingers cross that it'll remain stable. I'll try to figure out how to mark this as resolved. 🙂
Thanks again!
Now try this!
You may need it in future.
