I bought a Nighthawk XR1000 and i keep getting this error invalid rpc request message i try reseting to factory settings updateing fireware but it say im in the newst fireware

How did you reset the router exactly? Does the error appear by just loading the page or after changing a setting?

reset to factury setting my holding the reset button with a paper clip for 10 sec i get the massage ever 10 to 15 sec also the http://192.168.1.1/ takes too long to load up

You will need to hold the reset button for 30 seconds, then release, wait 2 minutes for it to reboot properly then access it and see if it's working properly.

i did this i still get the massage and it takes a long time to load up the pages

Have you got Armor enabled? Does it disappear if you use the Microsoft Edge browser

invalid rpc request | NETGEAR Communities

22 Replies

Netduma-Fraser
NetDuma Partner
Jul 02, 2021
How did you reset the router exactly? Does the error appear by just loading the page or after changing a setting?
- iTzPedroHDi
  Aspirant
  Jul 02, 2021
  reset to factury setting my holding the reset button with a paper clip for 10 sec
  i get the massage ever 10 to 15 sec also the http://192.168.1.1/ takes too long to load up
  - Netduma-Fraser
    NetDuma Partner
    Jul 03, 2021
    You will need to hold the reset button for 30 seconds, then release, wait 2 minutes for it to reboot properly then access it and see if it's working properly.

Forum Discussion

invalid rpc request