NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
No "Click the Cancel button" on URL " http://orbilogin.com " RBR760 webpage.
KB 31016 talks about "Click the Cancel button" on URL " http://orbilogin.com " Orbi RBR760 webpage. So you can answer the security questions, and SN of the Orbi to reset the admin password.
Is there a URL to reach this page to reach this for the Orbi RBR760 ?
Could also solve the problem if I could find an option to reset the admin password from the IOS Orbi software that I used to setup the device. Can not find an option to do this anywhere.
Everything is setup the way I want it and I would hate to have to do a factory reset and put a very simple password like qwerty just so could get into the router to reset the password.
5 Replies
Try inputting a invalid password and I think on 3rd try or after, it should give you the password recovery page that you can input the RBR serial number. Once you get in you can change the PW if you need to under Advanced tab/Admin
Well that did not work with Safari, Chrome, or Firefox... My router is at 10.0.0.1 is it is a subnet with the wan port on the 192.168.0.0 network. All that it did was come back with a page with this IP address and a Continue button that just took me back to the login page.
So if anyone who used the method you talked about to get the "Cancel" button to show up. What URL does this take you to once you click it?
Your ISP Modem already has a built in router and wifi. This would be a double NAT (two router) condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
https://kb.netgear.com/30187/How-to-fix-issues-with-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge or modem only mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktop
Try option #2 first...
https://kb.netgear.com/000061277/Which-features-are-disabled-on-my-Orbi-router-when-it-is-set-to-AP-ModeWire connect a PC to the router and factory reset the router using the back push pin button. Hold it in for 15 seconds then let go. Power OFF the ISP modem for 30 seconds than back on. Wait for the WHITE led to slowly pulsate on top of the RBR, then log in to orbilogin.com using a web browser and walk thru the setup wizard. This time write down all important information for safe keeping later on.
