RBK753 with extra RBS750, satellites led goes every 20 minutes to white and blue. Why?

Question

I bought a Orbi RBK753 set in begin 2022. I had no problems till I changed this year from internet provider. The RBK730 has to be installed as access point (AP). I bought also a new RBS750 to joint the RBK753.

After those changes, All the Satellites goes burning about every 20 minutes the white leds for 1-2 minutes and after that the blue led for 1-2 minutes.

All the RBK753 and new satellites has V7.2.6.31.

If I put down 1 satellite, then this problem of lighting up white and blue is gone.

Is there a solution if I like to use all satellites in AP?

Thanks Wim

FURRYe38 · Answer

Does turning OFF the other RBS and leavin the new RBS ON do same thing?
&nbsp;
What is the size of your home? Sq Ft? What is the distance between the router 📡 and satellite(s)🛰️? 30 feet or more is recommended in between RBR 📡 and RBS 🛰️ to begin with depending upon building materials when wired or wirelessly connected. https://kb.netgear.com/31029/Where-should-I-place-my-Orbi-satellite ‌‌🛰

Wim2019 · Answer

Kpn is the new provider.The AP is only possible for the orbi RBR750 and satellites with the router of Kpn.Size house is 120m2, the distance of the Orbi devices is about the 3 till 6 m.In yhe time the White and blue led is seening, theee is also a bad wifi.And there is a rear thing with the satellites. If there are only 2 satellites on, there is mo problem.If I use 3 satellites then every 20 minuten every satellites give the White led and about 2 minuten later a blue led.Is there a manual to downgrade the Orbi devices?

FURRYe38 · Answer

Try v.21 FW on the RBS first, then downgrade the RBR lastly.
You'll nee to factory reset the entire system and setup from scratch after the downgrade has been completed.&nbsp;
&nbsp;

Wim2019 · Answer

Thanks all for your helps.&nbsp;Is there a helping manual to downgrade the firmware of satellites and router?&nbsp;Or can I downgrade the firmware on the same way as installing newer firmware?&nbsp;Wim

Wim2019 · Answer

I like to start with the downgrade for RBS750 to V7.2.6.21.&nbsp;Is the procedure for downgrade the same as the procedure for upgrade with the firmware?&nbsp;Because in the manual there is only described the upgrading.See for manual:&nbsp; www.netgear.com/support/product/rbk753/#docs.See page 80+81 from the manual.&nbsp;Greetings Wim

Forum Discussion

RBK753 with extra RBS750, satellites led goes every 20 minutes to white and blue. Why?

5 Replies