RBR850 Firmware V3.2.17.12_1.4.14

Question

I manually updated my RBR850 and Satellite with the 3.2.17.12 firmware and having random disconnects since. Anyone else? This is the first time I've run into issues in the 6+ months that I've used it.

RT

FURRYe38 · Answer

Has a reset and setup from scratch been performed since update?

Is Traffic Meter enabled? If so, disable this...

What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

rtrueman · Answer

Thanks for the reply! I've rebooted, but not reset and setup from scratch. Is that really needed for every firmware upgrade? Yikes! No, the traffic meter is off (double-checked to make sure). I'm connected directly to my Verizon FIOS ONT.&nbsp;

FURRYe38 · Answer

Sometimes yes.&nbsp;Is there any router built in to the ONT or is it just a ONT only?&nbsp;

rtrueman · Answer

Okay, I'll rebuild if it keeps happening. It shouldn't be too bad.&nbsp;I don't know about the ONT. I assume so as it's working without the cable router. We had Verizon make changes to the ONT years back as we weren't using the cable boxes and I purchased my own router. I didn't realize it worked without the router until I mistakenly hooked up the Orbi system, got it working, and realized the Verizon modem was sitting on the kitchen table. Oops!&nbsp;

FURRYe38 · Answer

Well hopefully it's not needed.&nbsp;&nbsp;Be sure to save off a backup configuration to file for safe keeping. Saves time if a reset is needed.&nbsp;:smileywink:

Forum Discussion

RBR850 Firmware V3.2.17.12_1.4.14

7 Replies