RBR850 WAN status

Question

Just switch from a Ubiquiti setup to the Orbi 6 RBR850. Gigabit Fiber connection, with a CAT6 cable going from the fiber modem to the Orbi router, but I'm only seeing 100M/Full for the WAN port status. Any suggestions?

FURRYe38 · Answer

What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

Swap LAN cables between the ONT and RBR.

What happens if you connect a PC to the ONT directy. Do you see 100Mb or 1000Mb?

cmoccari · Answer

Thanks for the reply.&nbsp;I'm on the latest firmware:&nbsp;V3.2.16.6_1.4.4&nbsp;ONT is&nbsp;Adtran 401.&nbsp;I've tried swapping CAT6 cables between the ONT and the Orbi router, and I'm still seeing 100M/Full for the WAN port.&nbsp;&nbsp;

FURRYe38 · Answer

What happens if you connect a PC to the ONT directy. Do you see 100Mb or 1000Mb?&nbsp;Has a power OFF of the RBR and RBS for 30 seconds since last FW update been performed?&nbsp;

cmoccari · Answer

So going directly from the ONT to a gigabit switch, I'm getting 1000M. So it's not the ONT. I'm getting 100M on the Orbi WAN port going direclty to the ONT and also going to the gigabit switch.&nbsp;&nbsp;Is there a way to force 1000M on the Orbi? Why would it be auto-negotiating 100M?

FURRYe38 · Answer

What is the mfr and model# of this swtich?&nbsp;Sounds like the WAN port on the RBR is faulty. I would try another Orbi AX system and see if the problem continues or not. I hope not.&nbsp;

Forum Discussion

RBR850 WAN status

9 Replies