Can an RAX200 inject all or part of an R7000 config?

Question

I have an R7000 with access control enabled with MAC address of many devices configured. &nbsp;Is it possible that these can be injested by the RAX200?&nbsp;Thanks.

plemans · Answer

Not sure w&nbsp; hat you mean by that. Are you trying to take the configuration from you R7000 and use it for a RAX200?&nbsp;If so, please don't (at risk of your device). Just write them down or take a screen snip and then manually input them.&nbsp;&nbsp;

_aps · Answer

&nbsp;plemans&nbsp;wrote:Not sure w&nbsp; hat you mean by that. Are you trying to take the configuration from you R7000 and use it for a RAX200?&nbsp;If so, please don't (at risk of your device). Just write them down or take a screen snip and then manually input them.&nbsp;&nbsp;Thank you for answering. &nbsp;Yes, I was asking if I can take the configuration info from my R7000 and use it to get an RAX200 up and running. &nbsp;I was asking here to avoid "risking" the RAX.&nbsp;Does anybody know if this works? &nbsp;Do Netgear support people read these?&nbsp;I would be surprised (and, of course, dissappointed) were there not a way to extract the things that make sense (IP addressing, DHCP scopes, MAC addresses for access, etc.).&nbsp;&nbsp; &nbsp; aps

Forum Discussion

Can an RAX200 inject all or part of an R7000 config?

2 Replies