NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RAX20 / AX1800 Remote Management not working.
On my RAX20, I'm needing to access it remotely. The setting is correct for remote management, the port is set. When I place the IP and port (IP:Port) I'm getting page cannot be found. What am I missing?
Yes, I understand the security risk, but this is only temporary.
5 Replies
> [...] When I place the IP [address] and port (IP:port) [...]
What is this "the IP [address]"? From where are you trying to access
it?The IP address I mentioned is the PUBLIC IP from Spectrum assigned to me presently.
> The IP address I mentioned is the PUBLIC IP from Spectrum assigned to
> me presently.I'll try again.
> What is this "the IP [address]"? From where are you trying to access
> it?What's the WAN/Internet IP address of the RAX20? To what is the
WAN/Internet port of the RAX20 connected?If you're worried about revealing secrets, then the top half of an
address, "a.b" out of "a.b.c.d", would satisfy my curiosity.General advice: Count the question marks ("?"). Count your answers.
