My RAX200 is unable to maintain the speed i get from my ISP. I had small issuses before the latest update V1.0.5.132_1.0.69 but nothing like this. So today i have tried reseting to factory defaults. When it boots up im able to get the speed around 900-1200mbps.After 30min or so I'm unable to get this speed any more, caps in around 530mbps or less. Reboot of the devices allows me to achive the full speed again, but only for max 30min. I have tried connecting my computer to my ISP modem and no issue constant 1100+mbps.I'm getting really tired of this :(

Jimmy_W wrote: FURRYe38 Sorry I did post that i tested WiFi from the Router, but this was only for testing. I get modem information from the brand and model # you mentioned about your modem. If modems have wifi built in, then there is a router as well. When the modem is in ROUTER mode, the RAX can be either in router mode if you use the modems DMZ. IF not, then use the RAX in AP modem. When the modem is in BRIDGE mode, the RAX needs to be in router mode. Modem = Bridge Mode no WiFi on, This now causes the NG to get half the speed i have. Modem = Bridge Mode, Turn on WiFi on Modem for testing, this gives me full speed Modem WiFi. <Not sure how this can be done since most most when put in to bridge mode, you can't enable WIFI Radios in this mode. You sure your not putting the modem back in to router mode when you enable wifi here? The wierdest part now, after testing entire weekend. Modem = Bridge Mode, WiFi turned on, one device connected to the Modem WiFi. This gives me full speed on NG, for 2 days now i have had 1230mbps< This would not be bridge mode, this would be router mode. When i ask my ISP they say my modem is in brigde mode, I do create a double NAT by turning on the WiFi but for some wierd reason this gives me perfect speed and lower latency on the NG.

What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too? Speed testing with a wired PC or wireless?

FURRYe38 I will update tomorow with the Mrf and model, but im located in Sweden. I messure with cable and wireless and from the admin panel of the router. If the speed drops it's the same on all three interfaces.If i reboot i get 1100+mbps with cable maybe around 900-1100 with wireless WiFi 6 band and normal 5ghz speed around 850-950mbps.

FURRYe38 This is the info i have on the modem.Model: F@ST 3896 CHCom Hem WiFi Hub C3

RAX200 Unable to maintain speed | NETGEAR Communities

12 Replies

FURRYe38
Guru
Oct 18, 2021
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

Speed testing with a wired PC or wireless?
- Jimmy_W
  Guide
  Oct 18, 2021
  FURRYe38 I will update tomorow with the Mrf and model, but im located in Sweden.
  
  I messure with cable and wireless and from the admin panel of the router. If the speed drops it's the same on all three interfaces.
  If i reboot i get 1100+mbps with cable maybe around 900-1100 with wireless WiFi 6 band and normal 5ghz speed around 850-950mbps.
  - FURRYe38
    Guru
    Oct 18, 2021
    Ok, will need ISP modem info.

Forum Discussion

RAX200 Unable to maintain speed