NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

The-Ark's avatar
The-Ark
Guide
Sep 08, 2020

RAX80 Firmware Version 1.0.3.102 Link aggregation Not working

After update RAX80 Firmware  to Version 1.0.3.102

Link aggregation Not working anymore

Can not connect to my network device using Link aggregation.

I will have to roll back to Version 1.0.2.76.

 

Any one know how to fix Link aggregation on new firmware?

5 Replies

Sort By
  • plemans's avatar
    plemans
    Guru
    Sep 08, 2020

    After the update/issue did you try a factory reset? 

    If an old setting is causing an issue, many times a reset after firmware changes can fix it. 

    • The-Ark's avatar
      The-Ark
      Guide
      Sep 08, 2020
      I did a factory reset.
      Still can not use Link aggregat

      I believe its firmware issue
      • jcax's avatar
        jcax
        Star
        Sep 08, 2020

        No idea if this following will help you address your issue, but I hope so.

        I have upgraded from build 99 to 102. Had a bit of trouble.

        I had link aggregation working with my NAS on 99, but had trouble getting the upgrade to 102 to succeed. It kept failing with error on updating language table (see this post https://community.netgear.com/t5/Nighthawk-Routers-with-WiFi-6-AX/RAX80-New-Firmware-Out-Today/m-p/1971582/highlight/true#M12486.

        I tried doing a factory reset on 99. After that the 102 was successfully installed as part of the initialization process.

        Note that I had my NAS shut down during this whole process.

        I updated configuration of RAX80 to turn on link aggregation. Restarted the NAS. Link aggregation reestablished successfully.