RAXE500 ethernet port 3 failure?

Any progress on this? 

dunc101 wrote:

Hi all - help please! Ive been more than happily using my RAXE500 a while now, and have enjoyed utilising link aggregation to my NAS using ethernet ports 3 and 4. 

 

But I noticed recently my NAS reporting one of the LANs was down. Also, port 3 on the nighthawk is now not lit. 

 

Ive checked and cleaned all ports, rebooted, firmware updated, factory reset, confirmed internal cabling (cabling is fine), but port 3 will not respond and link aggregation whilst enabled remains, now, inactive.

 

What troubleshooting / resulution steps might I look at next? Im hoping ive not now permanently lost this port, and therefore also link agg.