NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
C7000v2 in Bridge Mode - Can't Connect
Hello Everyone - I am adding mesh to the house & opted to keep my C7000v2 & use it as modem only leveraging the "bridge" or no router selection. I am connected directly to the C7000v2 via an ether...
Try 192.168.100.1
txamasonrob wrote:
Hello Everyone -
I am adding mesh to the house & opted to keep my C7000v2 & use it as modem only leveraging the "bridge" or no router selection. I am connected directly to the C7000v2 via an ethernet cable & can access the internet; however, I am unable to access the C7000v2 via the 192.168.0.1 address or the remote management https address. I also tried to access both addresses from my phone on its own provide network and still nothing. In addition, my mesh node is unable to pull any address from the ISP through the now acting as modem only device. Any ideas?
txamasonrob wrote:
I am adding mesh to the house & opted to keep my C7000v2 & use it as modem only leveraging the "bridge" or no router selection.
While many questions about routers are generic and could be answered anywhere, some things need specialist knowledge. In this case you are talking about a feature that has nothing to do with the Nighthawk WiFi Routers covered here.
You might get more help, and find earlier questions and answers specific to your device, in the appropriate section for your hardware. That's probably here:
Cable Modems & Routers
I will ask the Netgear moderator to move your message.