NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
cabletester GS305E reports faults on new cables
Netgear cable tester reported some faults in my existing CAT5-cables, so I decided to replace the lot with new CAT6-cables (eventhough the existing cables seemed to be working fine). And, would you b...
Please post about this in the Switch forum.
Good Luck.
LexNoyb wrote:Netgear cable tester reported some faults in my existing CAT5-cables, so I decided to replace the lot with new CAT6-cables (eventhough the existing cables seemed to be working fine). And, would you believe it; I just connected one side of 2 brandnew 15-metre cables, and the cable tester reported a fault at 13 metres! I then switched the cables around, and connected the other side of them - SAME result!! Here also, it reported a fault for BOTH cables at 13 metres.
The new cables are branded as S/FTP (PiMF) LSZH, CU.
From what I read about it, such cables would be fine, up to 50 metres, or even 100 metres.
So, what's up with that?
Should I take Netgear Cable Tester with a pound of salt?
Is it just too picky?
I noticed the Switch option before I signed on; after that, under Home Network it never showed again, so that routers/modems seemed the best (and only) choice.
Thanks for that info; I have posted my question there. So consider this issue closed.
I just hope my Switch isn't going to be as quirky as the website :).