NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
CM1000v2 Will not boot - all lights flashing rapidly
I have had this cable modem since July and it was working without any issues until a couple days ago. It seems like it will not "boot" up after powering it on. All of the lights, except for the ether...
Mine too. Been working great for 6 months. Woke up this morning to the same issue as everyone else.
Please post a copy and paste of the modems connection status page.
Have the ISP check the signal and line quality UP to the modem. Be sure the ISP provisions the modem correctly.
Be sure there are no coax cable line splitters in the between the modem and ISP service box.
Be sure your using good quality RG6 coax cable up to the modem.
Be sure to power OFF the modem for 1 minute them back ON.
https://community.netgear.com/t5/Cable-Modems-Routers/General-info-and-Troubleshooting-for-Cable-Modems/m-p/1530376#M12853
Mrjones24 wrote:
Mine too. Been working great for 6 months. Woke up this morning to the same issue as everyone else.
- Can’t access modem connectivity page. It won’t connect to it.
ISP already checked everything else and said it’s the modem. Tried one of theirs and it worked. Definitely a hardware issue.Probably is then. You'll need to contact NG support to see what your options are. Good Luck.
- Same issue as everyone here. What has been the resolution (if any)?
No fix other than getting a new modem.