NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Trying to determine if CM1000 is losing internet connection
For the past few weeks, I've been having an issue in which my internet connection would be lost, with amber light on my R8000 indicating that there is a problem, and loging into my router showed no i...
1: v2.01.15
2: Blue Ridge Communications (brc.tv)
3: I uploaded screenshots of the logs to my onedrive here: https://1drv.ms/u/s!AnLtkirRVT30k7pZYKbUufn7-w7F7A?e=r9jK74
4: Can't pin that down. When it happens, it happens several times within minutes, and I would have to reboot the router 4 or 5 times before it settles, then I could use the net for hours without a hitch.
5: I pay for 500mbps down, 15mbps up. according to speedtest.net, I achieve about 300 down and 15 up on both their Windows App and website. however, the speedtest on ptd.net (the actual service for BRC for my internet) I achieve above the speeds i'm paying for. I have done the tests with task manager open and to my surprise, yes even windows is saying I'm achieving those speeds while using their speed test.
6:V1.4.1.30_1.2.26 (the prior R8000 also had the latest firmware)
7: Except changing the Wifi SSID and passwords and changint he router password, the only other setting that was changed is I turned off UPNP. That's somthing I've been doing since i left the world of dial-up modems 20 years ago. And I only access my router directly in the web browswer. I don't use a phone app or that routerlogin website.
8: I have a Netgear 5 port switch connected to my R8000P via a 50ft ethernet cable for my two tower computers (one for work and one for play). I tried removing the switch, hooking the one machine directly to the router and the other via a USB wireless dongle, didn't fix anything.
9: The DNS settings currently are whatever my ISP provides, and again, that didn't fix the situation.
I have an ethernet pin tester and so far all connections are good. I don't see damage to the coax cable. The only cable I haven't swapped is my 50 ft cable I used to wrap around the room to where my computers are.
Your downstream signal is low and out of spec. Your upstream is within spec but probably a touch on the high side. Between your downstream being low and your upstream being on the higher side I'd be looking at signal from your provider. Try what I suggested on moving the modem to right where it enters the house and if your signals are still the same, I'd make your ISP check them. Remove any splitters/amplifiers from the line for testing. Your sync issue in the logs point to this too.
Thank you for your reply. I'll see what I can do but I'm sure I'll be forced to drop my netgear stuff for their garbage just to get some support. :\
They might not support your device but they need to make sure they're providing your proper signal to your residence. I'd try the replacing connectors and lines
Just as an update, according to them the signals are well within tolerances (they don't trust what a modem they don't support is telling me) and to them it's more likely an effect of living in rural north east PA. A tech is coming to install their router/modem and if the problems persists then they'll check the lines. Welcome to a monopoly ISP. :-)