NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Can't Connect to my N300 Range Extender
Hi guys, I purchased an N300 EX2700 WiFi Range Extender yesterday, plugged it all in, did the set up and everything was fine, everything connected. I went out today then came back and noticed I wa...
Babylon5 wrote: The 'oops' message usually means that you are not actually connected wirelessly to the extender, but instead you are connected to the router. Can you connect to it with an Ethernet cable?
I've managed to log into the mywifiext site but I'm not sure how to check whether I have a good connection to the router?
Under 'STATUS' I get these readings:
Status
Hardware Version EX2700
Firmware Version V1.0.0.22
GUI Language Version V1.0.0.27
Connection Status to Existing Network
Operating Mode Extender
Name (SSID) BTHub5-MFQJ
Connection Status Connected
Link Rate 130Mbps
Extender IP Info
MAC Address A0:63:91:7F:AC:13
IP Address 192.168.1.81
DHCP Client ON
IP Subnet Mask 255.255.255.0
Gateway IP Address 192.168.1.254
Domain Name Server 192.168.1.254
Extender Wireless Setting
Name (SSID) BTHub5-MFQJ_EXT
Region Europe
Channel 1
Wireless AP ON
Broadcast Name ON
Wi-Fi Protected Setup