I tried updating firmware and I think the update failed and now the power light is flashing continuously. Cannot access via lan cable and wireless signal is not functioning.

BKKbob Those steps should help you. Did you still proceed with the rest of the step even you didn't get a blinking green power LED? If that step didn't help, see this other link for a different TFTP step.

AC1450 power light flashing after firmware update

5 Replies

ElaineM
NETGEAR Employee Retired
Feb 22, 2016
You may want to try to use this link to recover it.
- BKKbob
  Aspirant
  Feb 22, 2016
  Thanks to ElaineM for providing detailed instructions.
  
  I tried following the steps in the link (http://kb.netgear.com/app/answers/detail/a_id/22688/~/how-to-upload-firmware-to-a-netgear-router-using-tftp), but when I got to step 5 through 10, I was not able to get a "flashing green" power LED. When holding down the reset button and turning on the power, all 4 LED's came on momentarily, then all went off except the power LED which then began flashing beige/yellow. All lights then go off and the reset sequence starts again. I tried doing the reset first without the DSL internet cable attached, and then with the internet cable attached.
  
  Any ideas on how to perform a successful reset and get a solid green or blinking green power LED?
  - ElaineM
    NETGEAR Employee Retired
    Feb 23, 2016
    BKKbob Those steps should help you. Did you still proceed with the rest of the step even you didn't get a blinking green power LED?
    
    If that step didn't help, see this other link for a different TFTP step.

Forum Discussion

AC1450 power light flashing after firmware update